Waterford-appliances NATURAL GAS E61-LP Manuel d'utilisateur télécharger pdf (Page 4)

4 Waterford E61 Gas Fireplace Insert

This is a copy of the label that accompanies

each Waterford E61-NG Gas Insert Natural

Gas. We have printed a copy of the contents

here for your review. The safety label is located

on the right side door panel.

NOTE: Waterford units are constantly being

improved. Check the label on the unit and if there

is a difference, the label on the unit is the correct

one.

SAFETY LABEL

For the State of Massachusetts, installation

and repair must be done by a plumber or

gasfitter licensed in the Commonwealth of

Massachusetts.

For the State of Massachusetts, flexible

connectors shall not exceed 36 inches in

length.

For the State of Massachusetts, the appli-

ances individual manual shut-off must be a

t-handle type valve.

DUPLICATE SERIAL NO.

DO NOT REMOVE OR COVER THIS LABEL /

NE PAS ENLEVER CETTE TIQUETTEÉ

205

FPI Fireplace Products International Ltd., Delta, BC, Canada

Serial no./

No de serie

908-419b

Made in Canada/Fabrique au Canada

ÉÉQUIP A L'UISINE POUR GAZ NATURAL

5" WC/C.E. (1.25 kPa)

3.8" WC/C.E. (0.94 kPa)

1.1" WC/C.E. (0.27 kPa)

#33 DMS (2.87mm)

200

36,100 Btu/h (10.57 Kw/h)

18,000 Btu/h (5.28 Kw/h)

0-4500 ft/pi (610-1372m)

Minimum supply pressure

Manifold pressure High

Manifold pressure Low

Factory Equipped for Altitude 0-2000 ft.

Maximum Input

Minimum Input

Orifice size

Altitude

Convertible to 27,000 Btu for Altitude 0 - 4500 ft. with Kit #: 260-920

Maximum Input

Minimum Input

Orifice size

Altitude

Convertible for Altitude 2000-4500 ft.

Maximum Input

Minimum Input

Orifice size

Altitude

FACTORY EQUIPPED FOR NATURAL GAS Model:E61NG

Pression d'allimentation minimum

Pression la tubulure d' chappement lev e

Pression la tubulure d' chappement basse

ééé

38,000 Btu/h (11.14 Kw/h)

19,000 Btu/h (5.57 Kw/h)

#32 DMS (2.9mm)

0-2000 ft/pi (0-610m)

27,000 Btu/h (7.91 Kw/h)

13,500 Btu/h (3.95 Kw/h)

#40 DMS (2.49mm)

0-4500 ft/pi (0-1372m)

D bit Calorifique maximum

D bit Calorifique minimum

Dimensions de l'orifice

L'altitude

D bit Calorifique maximum

D bit Calorifique minimum

Dimensions de l'orifice

L'altitude

D bit Calorifique maximum

D bit Calorifique minimum

Dimensions de l'orifice

L'altitude

This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an

aftermarket, permanenlty located,manufactured (mobile) home where not prohibited by local codes. See owner's

manual for details. This appliance is not convertible for use with other gases, unless a certified kit is used.

Minimum Clearances

to Combustibles/

Degagement Minimum

De Materiaux Combustibles

Unit to Sidewalls A 9"/230mm

Top of Hob to mantel:

unshielded B 16"/406mm

shielded B 12"/305mm

To ceiling from top of stove: 36"/ 915mm

A floor protector consisting of one layer of ½" thick

WonderBoard , Durock , or equivalent extending

at least 9" in front of the face of the unit and the full

width of the front surface is required.

Floor Protector

This appliance must be installed in accordance with

local codes, if any; if none, follow the National Fuel

Gas Code, ANSI Z223.1/NFPA 54, or Natural Gas and

Propane Installation Codes, CSA B149.1.

FOR USE WITH GLASS DOORS CERTIFIED

WITH APPLIANCE ONLY.

This vented gas fireplace heater is

not for use with air filters.

Not for use with solid fuel.

Electrical Supply (115 V, 1.13A, 60 Hz)

Approved for use with Emerald Zero Clearance Kit, Part No. 270-900.

Listed:

Report No.

VENT GAS FIREPLACE HEATER

476-1714-00 (Oct. 1999)

Certified for/Certifi e pour: CANADA and U.S.A.é

ANSI Z21.88b-2003/CSA 2.33b-2003, /CGA 2.17-M91Tested to: CAN

1 2 3 4 5 6 7 8 9 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Waterford-appliances NATURAL GAS E61-LP Manuel d'utilisateur Page 4

Commentaires sur ces manuels